| Is it possible to convert the spindle of the Tele centric 70 K on to the Tele centric 70 M? |
From the perspective of ALLMATIC would not fit a spindle conversion with the strategy of
zero point clamping system and jaw quick-change system. |
| What is the error in parallelism on the work piece ? |
0,3 mm error in parallelism. |
| How many “1/100 mm” is a tick mark at the Centre offset of the Tele Centric |
A tick mark equals 2/100 mm. |
| How is the repeatability of the Tele Centric? |
With the same clamping force and same clamping situation within 2/100 mm. |
| Are all of the Tele Centric clamping jaws equipped with the quick-change system? |
Yes |
| Are both versions of the Tele Centric the same height? |
Yes. Both versions can be used side by side on a table. |
| How many Newton meters must the clamp screw on the center column be tightened? |
Please tighten with a torque of 4 NM |
| What are the caps at the bottom use for? |
These are caps for the screws holes for mounting options. |
| Is the clamping force progression linear? |
Yes |
| Which tool is used with the Tele Centric? |
The span adjustment is set with the included hand crank. The actual locking process is
only done with an adjustable torque wrench. |
| How can you attach the Tele Centric on the machine table? |
Either through a zero point clamping system with a depth gauge size of 200 mm, directly
through the base by means of screws M12 in the grid of 50 or 63 mm and sliding blocks or with clamps |
| Is the Tele Centric applicable for which zero point clamping systems: |
Zero Clamp, Schunk Vero S, Gressel, Innotool, Kipp, Fresmak, AMF, Stark, WNT, Vischer
& Bolli. |
| How does the interference contour of the Tele Centric with small work pieces compared to large work pieces? |
The interference contour remains unchanged through the telescopic spindle. |
| What does the QR-code on the nameplate mean? |
There, the serial number is displayed and you get to the website of ALLMATIC. |
| Can you clamp from inside to outside with the Tele Centric? |
No |